![]() ![]() Use a tape measure to space it ¼ inch from the first. Place your second deck board beside the first. Drive two screws, or nails, through the decking board, into each deck joist, where they meet. ![]() Position deck boards, starting even with the outside face of one side rim joist. Cut enough decking to cover the entire surface, with ¼ inch space between each piece. Measure and cut 1 1/4 by 6 inch decking boards to fit parallel to the side rim joists, so that the ends of the decking boards are flush with the outside faces of the front and back rim joists. Nail, or screw the pieces in place, driving the fasteners from the outside of the rim joists into the ends of the deck joists. Measure and cut one piece of two-by-six inch lumber to fit horizontally between the two vertical side pieces of your frame, every 16 inches on center from the front to back of your deck as joists to support the deck planks. Top Sellers Most Popular Price Low to High Price High to Low Top Rated Products. Adjust, as needed, by either digging out from under, or adding dirt underneath the blocks, until all four corners are level. 8 Results Building Supply Product Type: Concrete Block/Brick/Lintel Block Type: Deck Block Clear All. ![]() Use a level to check that the blocks are level with each other by placing the level on top of the wooden frame. Position the frame you just built on the corner blocks so that the boards set into the grooves in the tops of the blocks and the corners of the frame align with the blocks. Use a drill and screw bit with screws, or a hammer and nails to fasten the corners together. Set one narrow edge facing up on each board. Set the four rim joists on end to form a square or rectangle, depending on the dimensions of your deck. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |